Airsoft Ball Bearing Drawer Slide 3D Printer Model
The file 'Airsoft Ball Bearing Drawer Slide 3D Printer Model' is (stl) file type, size is 94.7KB.
The file 'Airsoft Ball Bearing Drawer Slide 3D Printer Model' is (stl) file type, size is 94.7KB.
Make you project glide with these linear drawer slides, made with airsoft pellets as ball bearings.
Materials needed:
3D Print
Airsoft Pellets
Lighter/Match
WD-40
Instructions:
Line up the chamfered holes so they are facing each other.
Insert 4 airsoft bearings into each side
Slide the inner rod 90% on till the hemispheres in the front of the rails are half covered
Insert a bearing in to each of the hemispheres in the front and pull the rod
Pull the rod forward till the hemisphere on the back of the rod are half covered
Insert 2 bearings into the back of the rod.
Pull the rod all the way forward till it stops
Using a match or lighter heat up the back tab until it is soft and pliable
Using the match stick or stick flip the tab up to lock the assembly in place
A few drops of WD-40 on the bearings goes a long way.
Caution Hot Things are Hot
| Drawer_Slide_Assembly.stl | 426.9KB |
![Male Regulator Cap [1/2 NPS -14 Thread] 3D Printer Model](https://res.3axis.co/a0abfa41-b681-4972-865e-dcc10df663f1/images/f0ef2d60-a447-4831-bc64-d5a81daf8e9e_thumb.jpg)
