Quick design of an air vent mount for the Autool X60.

Sketch is rough and has some gaps but will work fine.
This design allows for a tilted gauge towards the driver's side for better view even on sunny conditions,while still utilizing the air vent.

TO INSTALL
Remove the entire air vent, remove the two fins and install the 3d printed part. A small portion of the honeycomb on the rear has to be cut for the USB wire to pass through.
Pop back in place, connect the gauge and secure with some double sided tape or medium strength glue.
You also have to cut the 3 notches on the bottom of the gauge in order to fit.

I passed the OBD2 wire through the center console, under the steering column and then through a gap next to the air vent.
I also used zip ties to secure the wire tight.

SUITABLE for Renault Clio 4, and various Renault models .

Beware, of outside temperature as well as car's heating system temperature , PETG,ABS,ASA is recommended.

Feel free to post remixes and makes.

Have fun!

EDIT
I also made a second version that features a honeycomb-like design instead of a cross and a cut out on top for easier access to the button.Also added one for 62mm Gauges, havent test fitted it tho