Air Powered Top V2.1 3D Printer Model
The file 'Air Powered Top V2.1 3D Printer Model' is (SLDPRT,STL) file type, size is 489.1KB.
The file 'Air Powered Top V2.1 3D Printer Model' is (SLDPRT,STL) file type, size is 489.1KB.
An air-powered top, based off the design made by Make Anything. Not a copy, but an attempt at one using only visuals and my own understanding of tops and air power. Will spin by just blowing, but works best with a large straw or something similar. A file for a straw specifically for this top may come soon.
This variation is designed to have a 1 1/4" finishing nail (about 1.5mm thick) pushed down through the center to use as a hard, wear-resistant point. This also makes the top's height adjustable, and allows you to spin it by hand as well as with air. For the regular version, go here - http://www.thingiverse.com/thing:1983724
The top prints best upside down with no supports.
A special thanks to Make Anything for letting me mimic his design, check his out here-
http://www.thingiverse.com/thing:1768027
| heilical_top_nail.SLDPRT | 514.5KB | |
| heilical_top_nail.STL | 375.2KB |
