This tool holder was created because my desk was a mess of tools, tape, hotends, and glue sticks. It fits on the side of the roStock Max V2 with just two screws and holds everything you need. 4 pairs of pliers of various handle widths, 2 glue sticks holders, Digital Calipers, SeeMeCNC putty knife, Sharpie, Razor blades, Kapton Tape Holder, 4 Hot End Sizes that are labeled (.35mm, .4mm, .5mm, .7mm), Multiple slots for screw drivers
When printing, use PLA and not ABS. I didn't put mouse ears on it for ABS so it could warp. You also need to print with Supports. I recommend 0.22mm per layer with a 35% infill. It should be strong and sturdy, not necessarily pretty.
| rostock_tool_holder.stl | 228.1KB |
