note 05/12/2018 - Updated Google Sheets parts list and links
This is a variation of the Adoptabot by Printrbot. Being in the UK some parts are easier to get than others so i have modified the brilliant little adoptabot by Brook to use easily available Ramps and E3D parts.
I have also added a cover for the Ramps board as well as a rear power input section along with an on/off switch and cooling fan for Ramps.
The lead screw has been changed to a standard TR8*8.
Additional tie wrap areas have been added to the Extruder Mount and Z Plate.
A List of the modified files are below ( it's basically all of them )
| Bed_Plate.dxf | 2.2KB | |
| Belt_Tensioner.stl | 33.9KB | |
| Case_1_Front.stl | 94.0KB | |
| Case_2_back.stl | 60.3KB | |
| Case_3_Rear.stl | 163.8KB | |
| Case_4_Ramps_Cover.stl | 97.7KB | |
| Display_Case_Front.stl | 163.2KB | |
| Display_Stand.stl | 49.1KB | |
| E3D_Fan_Shroud.stl | 347.3KB | |
| Encoder_Knob.stl | 266.7KB | |
| Extruder_Arm_-2.5_Degree.stl | 97.8KB | |
| Extruder_Arm_0_Degree.stl | 97.2KB | |
| Extruder_Base.stl | 162.9KB | |
| Extruder_Cover.stl | 105.6KB | |
| Extruder_Mount.stl | 49.5KB | |
| Part_Fan_Shroud.stl | 24.6KB | |
| Reset_Button.stl | 74.4KB | |
| TR88_Nut.stl | 187.6KB | |
| X_Bar_End_Left.stl | 36.3KB | |
| X_Bar_End_Right.stl | 41.5KB | |
| X_Clamp_Left.stl | 8.7KB | |
| X_Clamp_Right.stl | 8.7KB | |
| X_Plate.stl | 132.7KB | |
| Y_Bar_End_Back.stl | 33.1KB | |
| Y_Bar_End_Front.stl | 37.4KB | |
| Y_Plate.stl | 135.4KB | |
| Z_Block.stl | 60.1KB | |
| Z_Plate.stl | 96.2KB | |
| Z_Sensor_Mount.stl | 54.9KB | |
| Z_Top_Handle.stl | 46.0KB |
