Able to fully rotate, tilt up to 12 Degrees either side, and the lens can be shifted to center the image, designed for Canon a EF with separate designs to mount to OM and EF type mounts, very easy to switch out lenses and the whole body from your camera.
Video of movement in fusion 360: https://www.youtube.com/watch?v=1N1U65pr5S0
Print settings:
Resolution: 0.1-0.15mm
Infill: 20%
Rafts/Build plate adhesion: None
Nozzle size: 0.4mm
Support: Use supports on all pieces apart from the Bottom, the flanges should print fine without them
I would recommend a thick shell, at least 1.2mm thick walls, high top and bottom and top layer counts.
It is very easy to construct after printing, everything should snap into place with little resistance, the tilt and shift functions are held in place while shooting using 2 M3 thumb screws:
https://www.amazon.co.uk/QLWNWQAD-Computer-Thumbcrews-Repairing-installing/dp/B088KHKN29,
the rail system on the Top and Topmiddle piece will need a little initial sanding to slide smoothly, and everything should loosen up after a little bit of use.
Many components of this design are inspired by a design by bhautikj: https://www.thingiverse.com/thing:4684809
| Bottom.stl | 1.0MB | |
| Bottom_Middle.stl | 5.1MB | |
| TiltLens_v12.f3d | 2.8MB | |
| TopEF.stl | 1.6MB | |
| TopOM.stl | 1.5MB | |
| Top_Middle.stl | 4.3MB |
