Adjustable Pistol Brace 3D Printer Model
The file 'Adjustable Pistol Brace 3D Printer Model' is (step,stl) file type, size is 699.0KB.
The file 'Adjustable Pistol Brace 3D Printer Model' is (step,stl) file type, size is 699.0KB.
I liked the look of the Shockwave Pistol Brace but wanted it to be adjustable. So I combined the design of the Shockwave and DDA3 pistol brace into this design. This is designed for a mil-spec carbine buffer tube. The LOP is 13 1/8 inches so it meets the requirements to be qualified as a pistol brace.
The adjustment mechanism requires a spring with maximum diameter of 10mm. The holes for assembly require a 1/8 inch pin. These can be cut from brass rods available at both Home Depot and Lowe's. I used some 1/8 inch aluminum tubing that I had leftover from a previous project.
The print pictured was made using Paramound 3D Military Khaki ASA with a 0.2 mm layer height. The resulting print was then given two hot vapor baths to smooth away the layer lines.
| Lever.step | 39.7KB | |
| Lever_v4.stl | 20.8KB | |
| Pin.step | 27.1KB | |
| Pin_v3.stl | 104.7KB | |
| PISTOL_BRACE.step | 1.6MB | |
| PISTOL_BRACE.stl | 1.3MB | |
| Plug.step | 17.3KB | |
| Plug_v2.stl | 67.5KB |
