Required parts for assembly:
You can always use furniture screws instead of bolts with M3 nuts (this is much easier in terms of printing and you don’t have to wait for the right moment to place the nut in the mount part).
To print this holder I used PETG and PLA plastic. Supports are needed to print the part named "top" (not needed for vertical printing).
When printing a part with the name “mount”, it is necessary to place 4 M3 nuts while finishing printing the last layer of the mount under this nut.
The holes for attaching the part named “leg” to the part named “mount” are M4 in size and have a fixing hole for a bolt. The length of the M4 bolt for this mount depends on your needs.
I used M4 DIN 314 AF to fix the position of the product.
After final assembly, I glued soft pads on a self-adhesive base to the place where the top is attached (to hide the M3 screws), where the phone rests and on the base of the product (4 pieces along the edges of the platform) to eliminate slipping and shock absorption with the place where the product will stand.
| bottom.SLDPRT | 131.7KB | |
| bottom.STL | 86.6KB | |
| leg.SLDPRT | 640.6KB | |
| leg.STL | 1.2MB | |
| mount.SLDPRT | 407.0KB | |
| mount.STL | 606.6KB | |
| top.SLDPRT | 299.6KB | |
| top.STL | 266.6KB |
