Adjustable GPU Support Bracket 3D Printer Model
The file 'Adjustable GPU Support Bracket 3D Printer Model' is (SLDPRT,STL) file type, size is 204.0KB.
The file 'Adjustable GPU Support Bracket 3D Printer Model' is (SLDPRT,STL) file type, size is 204.0KB.
I designed this thing because I have a rather large graphics card that sags and I'm always worried I'm going to damage something when I transport my computer. This GPU bracket is completely adjustable to work with any GPU that has a heatsink cover, and should work with any case that has recessed expansion slots. It attaches via the existing expansion slots in your case. Extra materials include 5 small screws, and 2 small washers or a chain link, which is what I used. I printed this part with ABS filament on a XYZ da Vinci 1.0 printer. The back_plate should be printed with a relatively high infill density as there will be a lot of stress on that part. I printed all the other parts at 10% infill density.
Note:
-When I was first putting the screws in and creating the threads, the friction caused the wall in one of the holes to break. I recommend putting a bit of acetone in the holes to soften up the plastic when first making the threads.
-Take the care not to over tighten the adjustable slider, because on my first try I tightened it too much, causing the back plate to snap in two.
| Back_Plate.SLDPRT | 162.5KB | |
| Back_Plate.STL | 23.1KB | |
| Bracket.SLDPRT | 218.5KB | |
| Bracket.STL | 41.1KB | |
| Lifter.SLDPRT | 158.0KB | |
| Lifter.STL | 17.1KB |
