Simple adjustable leg to compensate for an uneven floor. When retracted it is 25 mm high. There is no limiter, so be careful.
It is made to be adjusted from inside the cabinet, so drill 8 - 10 mm hole over center of the leg before mounting. Mounting holes are for 3.5 - 4 mm screws.
Use flathead screwdriver to adjust leg height.
I printed leg_nut at 100% infill and leg_bolt at 50% infill.
ps. Again, I want to thank mike_mattala for a great Nut Job set.
| leg_bolt.stl | 3.2MB | |
| leg_nut.stl | 6.6MB |
