Adjustable Ear Saver 3D Printer Model
The file 'Adjustable Ear Saver 3D Printer Model' is (stl) file type, size is 30.6KB.
The file 'Adjustable Ear Saver 3D Printer Model' is (stl) file type, size is 30.6KB.
I created an ear saver/ear reliever design which enables you to use a 3/16" cord (cut to desired length) to attach both halves together and be able to adjust the length of the ear saver. If you don't have 3/16" cord, you can also opt to use an elastic hair band (medium size) instead by looping it onto itself as shown in the picture. Though, not adjustable in this fashion, the hair band should have plenty of stretch to make up for it.
The closed loop design for the mask's cord allows up to 1/8" cord to be passed through, while maintaining its ability to prevent the mask's cords from becoming disconnected from the ear saver. To help fight against hair snags, the loops are also created with a gentle slope which allows hair to pass back out with ease, making it hard to get hair caught in the loops (I have long hair and I tried a lot to get my hair caught in it).
Also, if your mask has cords bigger than 1/8", you can also trim back the loop with a pair of scissors to create a large enough opening for your mask's cords, but make sure to keep it tight enough to keep the cord inside.
| Adjustable_Ear_Saver.stl | 410.5KB |
![[V8.0] One/Two-Up Extruder With Lever And Adjustable Tension (E3D Support!) 3D Printer Model](https://res.3axis.co/ee4c5817-b473-4259-bcbf-002fb7e94e09/images/0be1ff5d-45da-4031-8164-056678bbe2df_thumb.jpg)
