I made this adjustable cup holder because i got tired of spilling energydrink all over my car.
It fits perfectly in the original cupholders for VW touran 1T3 2010 - 2015 models and It should fit anything from 0,5L to smaller sodaenergydrink cans.
Print with minimum 35% infill.
print the top part upside down and use support for the 4 flaps. ( see picture)
After printing the parts, remove the the support from the flaps on the top part.
Apply some preassure on the flaps and bend them towards the center of the cupholder.
wiggle them untill they move freely.
To assemble top and bottom part bring all flaps to center and twist on the bottom part.
Then bring the flaps back down.
| VWCupholder_bot.stl | 487.5KB | |
| VWCupholder_top.stl | 1.5MB |
