Adjustable Cell Phone Stand 3D Printer Model

Author: @
License: CC BY-NC-ND
File formats: stl,pdf
Download type: zip
Size:491.1KB

The file 'Adjustable Cell Phone Stand 3D Printer Model' is (stl,pdf) file type, size is 491.1KB.

Summary

Adjustable height cell phone stand with storage compartment for stand for portability. See video below (it's neat :-), well I think so :-)).

The cell phone is intended to sit vertical or horizontal. If sitting horizontal you can plug the charging cable in, but not when vertical as there is no pass through for a charging cable (this was by design as it was made for what I needed). There are 5 slots in the base that the stand can be inserted into that will change the angle (height) of the stand depending on which slot is used. There are 3 non-slip pads to reduce sliding of the base, stand and device.

Base.stl 206.2KB
Bottom_Curve_Non-Slip_Pad.stl 20.8KB
Device_Non-Slip_Pad.stl 684.0B
Insert_Left.stl 43.2KB
Insert_Right.stl 43.2KB
README.pdf 445.8KB
Stand.stl 44.0KB