Thank you for your interest.
We have announced a new model.
Adjustable angle tablet stand 2
https://www.thingiverse.com/thing:6741713
The STL data for some parts will be updated.
The Tab_Stand_Stay_S uploaded on 8/13 has been modified
to add a finger hook to make it easier to tilt.
The new data is Tab_Stand_Stay_S2.
Tab_Stand_Stay_S.stl will be left and not deleted.
Some of the stl data will be updated.
Add a protrusion to the existing Tab_Stand_Stay_1.stl
to prevent the stand from tipping over too much,
and add it as Tab_Stand_Stay_S.stl.
Tab_Stand_Stay_1.stl will be left and not deleted.
Improved the tablet base (Tab_Stand_Base_2.stl).
The axis has been extended by 1.5 mm and the rear of the rack has been made higher.
The data before the improvement (Tab_Stand_Base_1.stl) will not be deleted.
This is a tablet stand that can be adjusted from about 85 degrees to 45 degrees.
Support is required when printing.
| Tab_Stand_Base_1.stl | 1.7MB | |
| Tab_Stand_Base_2.stl | 1.7MB | |
| Tab_Stand_Holder_1.stl | 976.0KB | |
| Tab_Stand_Stay_1.stl | 1.1MB | |
| Tab_Stand_Stay_S.stl | 2.3MB | |
| Tab_Stand_Stay_S2.stl | 2.5MB |
