I made an additional drawer for CR-6 SE.
This fits on the front left side of the printer.
Minimum 2 parts to print.
-Outer Box
-Drawer Box (choose from 2 handle designs)
Optional parts
-Separator (vertical) max.3
-Separator (horizontal) max.3
-Push-in 30mm V-slot cover (to prevent from sliding backwards)
2 length types
-Long type
-Short type (choose this, if your spool holder is clipped on the front side)
Please mind the space under the heated bed when mounting/unmounting this drawer!!
Similar design to
[One More Drawer for CR-6 SE]
https://www.thingiverse.com/thing:4632086
[Another Drawer for CR-6 SE]
https://www.thingiverse.com/thing:4639083
[UPDATES]
-Changed Outer Box design. Added a bumper to prevent the drawer from falling out.
-Added hexagonal(honeycomb) cutout version. Uses less filament(-15g) (11/23/2020)
-No print supports needed
-Changed the length of short type drawer. (2/19/2021)
(Measurement was off on the previous model! This one should fit the spool holder. Thanks MediaBaron!)
| 30mm_V-Slot_Cover.stl | 2.6KB | |
| Creality_handle_drawer_Long.stl | 217.7KB | |
| Creality_handle_drawer_Short_UPDATED.stl | 217.7KB | |
| Hex_knob_drawer_Long.stl | 225.0KB | |
| Hex_knob_drawer_Short_UPDATED.stl | 225.4KB | |
| Outer_box_Long_Hexagonal.stl | 67.5KB | |
| Outer_box_Long_with_bumper_UPDATED.stl | 6.7KB | |
| Outer_box_Short_Hexagonal_UPDATED.stl | 65.1KB | |
| Outer_box_Short_with_bumper_UPDATED.stl | 6.9KB | |
| Separator_horizontal.stl | 8.1KB | |
| Separator_vertical_for_Long_drawer.stl | 3.0KB | |
| Separator_vertical_for_Short_drawer_UPDATED.stl | 3.0KB |
