This is an adapter to fit this adjustable y belt holder http://www.thingiverse.com/thing:745934 to this printable y carriage by mrwally here http://www.thingiverse.com/thing:1224624
The printable y carriage didn't have a good holder as far as I know so I made an adapter for it. even with the adapter the belt holder screw hole are quite wide and would hit the structure of the y carriage.
The adapter is quite thick but using the LM8UU holder here http://www.thingiverse.com/thing:1288284 are still okay, since there are still clearance for the the belt to go through. If you're using your own LM8UU holder, or wanted to make the holder above thinner, you can by up to about a maximum of 15mm lower. more than that the holder might be grinding the belt below it already
I'm using it for my friend's printer and it's working by the way. The clearance between bed and belt underneath it are roughly about 20mm
| y_belt_adapter.scad | 1.7KB | |
| y_belt_adapter.stl | 320.9KB |
