Adapter For Action Force Vanguard MG Turret 3D Printer Model
The file 'Adapter For Action Force Vanguard MG Turret 3D Printer Model' is (stl) file type, size is 125.6KB.
The file 'Adapter For Action Force Vanguard MG Turret 3D Printer Model' is (stl) file type, size is 125.6KB.
This is an adapter to allow the MG turret to elevate up and down on the Action Force Vanguard. This simple design employs two attachment arms for the MG part, and a single peg to insert into the turret. This allows for a range of around 70 degrees of up and down motion.
The adapter can be attached either front facing or rear facing, allowing you to get the range you want for any photos or displays. The mount is strong enough to hold the MG with blast effects but only in the fully raised position. The weight of the effect is too heavy for PLA, however with your figure holding the gun, any position is achievable. The Locusts have no chance now!
** IF I SEE THIS BEING SOLD ANYWHERE I WILL DELETE THE FILE AND MAKE AN EVEN BETTER VERSION, THIS IS ABSOLUTELY ONLY FOR SELF USE.***
| VanGuard_MG_adapter_mount.stl | 413.2KB |
