AA And AAA Battery Holders (4×6, 4×4, 4×1, 2×1 Sizes) Mk1 3D Printer Model
The file 'AA And AAA Battery Holders (4×6, 4×4, 4×1, 2×1 Sizes) Mk1 3D Printer Model' is (STL) file type, size is 793.4KB.
The file 'AA And AAA Battery Holders (4×6, 4×4, 4×1, 2×1 Sizes) Mk1 3D Printer Model' is (STL) file type, size is 793.4KB.
UPDATE: Slighly different version is here http://www.thingiverse.com/thing:2009923 (i removed some features of this revision, but added and adjusted different features, so you might want to have a look on that one as well)
There is lot of combinations of this model, hope you will find the one suits you. Again the orientation is off by 90, dunno why by what I setup as top in my software will get exported as front and not top :/
The cap and base are identical, only difference is the text caption on the corner.
The text caption should point the orientation of battery to show it's fully charged (if it's in opposite orientation it means it's drained).
Batteries can be held only in the base or only in the cap (if the somebody doesn't like the text), or both and cap can be used at the same time to fully conceal the batteries. Then zip-tie, string or rubber band can be used to keep the cap securely on.
The label text has 45 degree slope to allow easier printing on such edge.
| 2x1-aa-base.STL | 79.8KB | |
| 2x1-aa-cap.STL | 45.8KB | |
| 2x1-aaa-base.STL | 83.4KB | |
| 2x1-aaa-cap.STL | 43.8KB | |
| 4x1-aa-base.STL | 114.2KB | |
| 4x1-aa-cap.STL | 83.1KB | |
| 4x1-aaa-base.STL | 113.9KB | |
| 4x1-aaa-cap.STL | 78.4KB | |
| 4x2-aa-base.STL | 182.9KB | |
| 4x2-aa-cap.STL | 182.9KB | |
| 4x2-aaa-base.STL | 171.0KB | |
| 4x2-aaa-cap.STL | 136.4KB | |
| 4x4-aa-base.STL | 294.4KB | |
| 4x4-aa-cap.STL | 264.2KB | |
| 4x4-aaa-base.STL | 289.9KB | |
| 4x4-aaa-cap.STL | 254.5KB | |
| 4x6-aa-base.STL | 414.4KB | |
| 4x6-aa-cap.STL | 384.4KB | |
| 4x6-aaa-base.STL | 406.3KB | |
| 4x6-aaa-cap.STL | 371.5KB |
