This is Thin version (minimal version) for 9mm Snap-Off blades without support bolts (Please, see an other versions). You need ~10mm length M3 bolt and two nuts)). I cut off from the big one.
The author is not responsible for failed copies or damage. Everything must be done very strong as you can. ~ 95-100% infill. Please, be careful and not rush.
Supports: NO
Two body parts connected with a specific glue (I used dichlorethane).
| KDS_Knife_9mm_Thin_1.stl | 501.2KB | |
| KDS_Knife_9mm_Thin_2.stl | 473.3KB | |
| KDS_Knife_hand_9mm_R3.22_petg.stl | 357.8KB | |
| KDS_Knife_hand_9mm_R3.25_abs.stl | 366.7KB | |
| KDS_Knife_nut_holder_9mm_R3.22_petg.stl | 10.8KB | |
| KDS_Knife_nut_holder_9mm_R3.25_abs.stl | 10.8KB | |
| KDS_Knife_ring_9mm.stl | 436.0KB |
