This is a 90 bit holder for 1/4 hobby screwdriver bits designed to make it easier to adjust the mixture screw on my Honda Nighthawk Carburetors. The middle carbs are still a little difficult but much easier than using a regular screwdriver. I also trimmed the screwdriver bit to make it shorter.
To assemble the gears you need to heat the lip on the gear mount and bend it momentarily to slip the bottom gear in and then press it against a flat surface to reshape it. The gears are captured afterward.
This was printed in ABS, but would work fine in PLA
| 525inchext.stl | 26.4KB | |
| basev2.stl | 58.6KB | |
| horizgearv2.stl | 239.2KB | |
| vertgearv2.stl | 255.9KB |
