9 (70 Mm) Prong Espresso Distribution Tool WDT 3D Printer Model
The file '9 (70 Mm) Prong Espresso Distribution Tool WDT 3D Printer Model' is (f3d,stl) file type, size is 7.5MB.
The file '9 (70 Mm) Prong Espresso Distribution Tool WDT 3D Printer Model' is (f3d,stl) file type, size is 7.5MB.
This is a slightly modified version of the nine pronged WDT V3. The difference is in length of the needles used. This version is using 70 mm needles, where the original is using 105 mm needles. This is achieved by placing the needles deeper into the bottom part. With this modification they stick out ca 36 mm. Note that due to this modification it might require some fiddling to get the needles into the bottom part. The diameter of the needles stays the same: 0.35 mm. For other details please refer to the original design: 9 Prong Espresso Distribution Tool WDT.
Note that for me slicing with Cura 5 the needles did not fit, while slicing with Cura 4 works perfectly fine for me.
| For_70_mm_needles_v1.f3d | 7.0MB | |
| wdt_v3_bottom_70mm.stl | 516.0KB | |
| wdt_v3_top_70mm.stl | 907.5KB |
