This is a redesign for an 8040 printable propeller with a 5.5mm (13/64") bore.
This prop was designed to keep the minimum cross section above .8mm allowing it to be more easily printed, though at a small efficiency loss.
The propeller will require support on one edge, which makes it very easy to remove.
I can redesign this for some different center hole diameters if requested, just give me some time as I am pretty busy.
Here is a short video with the prop on a motor: http://www.youtube.com/watch?v=v6yClT12Ges&feature=plcp
I will also be uploading a 5030 prop once it is flight tested.
I printed mine on a Fablicator using Kisslicer.
| 8040_CCW_45deg_V1.stl | 406.0KB | |
| 8040_CCW_V1.stl | 406.0KB | |
| 8040_Counter_Rotating_Pair_45deg_V1.stl | 812.0KB | |
| 8040_Counter_Rotating_Pair_V1.stl | 812.0KB | |
| 8040_CW_45deg_V1.stl | 406.0KB | |
| 8040_CW_V1.stl | 406.0KB | |
| 8040_printable_propeller.SLDPRT | 7.3MB |
