EXPERIMENTAL test/attempt at a very robust , sweet leaf pattern, no bevels , no aerodynamics or care for lightweightness during design of this asacf made cinelifter shroud for poisonnous bee and similar 19x19 motor 7" quad. this is not design for performance , nor flight of anykind , its an endurance test nothing more . if it end up being good for anything i would be surprise as this is still at the testing phase. thread with caution

its made for a doubled frame 7" , the opening is for a 10cm ( 2x5mm arm) and should rest on the center shoe. if you only have one arm thick the opening wont rest on the arm for additionnal support, but with the amount of arms i dont think this design would tork that much compared to the 1mm proto i started with. for the nadir cam install additionnal shoes under the center shoe, weird sandwitch but its all solid with 35mm m3s... adding more shoes is unnecessary if you dont have a camera on the belly or you dont want to add more to your setup.

60mm high
187mm
2.1mm thick
arms 5mm thick - about 7mm wide, not aerodinamic sorry
100% infill
raft large, but try not to raft the whole plate
108g
about 120g with raft

DONT USE PLA - DESIGNED FOR ASACF