76mm Prop For BabyApeProV2 Version4.0 3D Printer Model
The file '76mm Prop For BabyApeProV2 Version4.0 3D Printer Model' is (stl) file type, size is 1.0MB.
The file '76mm Prop For BabyApeProV2 Version4.0 3D Printer Model' is (stl) file type, size is 1.0MB.
This is a propeller for drones with a rotating diameter of 76mm (3 inches) and a shaft diameter of 1.5mm.
The target model is assumed to be Darwinfpv Baby Ape Pro V2. It is better than the commercially available 3016-3 in the low RPM range.
The efficiency seemed to drop slightly at higher RPMs, and the actual cruising time was exactly the same compared to the 3016.
Recommendation:
Printer: FDM
Filament: PC
Use heat-resistant materials; otherwise, the propeller may detach during flight.
Caution:
After printing, file the propeller to clean it.
In particular, the 1/3 section from the tip should be finished as neatly as possible to minimize unevenness.
Also, use a drill with a diameter of 1.45 mm to prepare the axis of rotation.
| 20240817_76mm_v04.stl | 2.3MB |
