$5,000 Poker Plaques – Two Versions + Holder For 10 Plaques 3D Printer Model
The file '$5,000 Poker Plaques – Two Versions + Holder For 10 Plaques 3D Printer Model' is (stl) file type, size is 228.3KB.
The file '$5,000 Poker Plaques – Two Versions + Holder For 10 Plaques 3D Printer Model' is (stl) file type, size is 228.3KB.
I have designed simple $5,000 denomination Poker Plaques.
Both take around 2 hours to print on Super Quality.
Poker Plaques are used in lieu of multiple lower-value chips, or another single High Value chip so they can better stand out on the Poker Table, and typically start at $5,000 and above at Casinos.
Both feature a small Pine Tree logos on the plaque, which are embossed around 1.5mm below the surface.
Version 1
~73mm L x ~44mm W x ~3mm H
A common/typical size for Poker Plaques and displays two vertical denominations.
Version 2
~73mm L x ~44mm W x 3.5mm H
Matches the height of a standard poker chip and displays one large and horizontal denomination.
Plaque Holder
This is a holder with lid that will hold 10 Plaques of either version
Outside Dimensions: 80mm L x 51mm W x 40mm H
Inside 76mm L x 47mm W x 38mm H
Note: Holder + Lid will take about 11-12 hours to print at Super Quality.
| Plaque_Holder.stl | 88.4KB | |
| Poker_Plaque.stl | 363.5KB | |
| Poker_Plaque_Version_2.stl | 685.0KB |
