This picture frame is a little hard to print because of the fine detail, so play around with your slicer settings and pay attention to the print preview to see if it'll print the doo-dads! The detail part starts at 12mm, so if you want to do 2 processes and print fast until then, it makes the print go a lot quicker. Support is optional, depending on how your slicer slices it. But if you do use supports, be sure that they are "from the build platform only".
| picture_frame_4x6_v2_long_side.stl | 3.9MB | |
| picture_frame_4x6_v2_short_side.stl | 4.2MB |
