4runner Ram Sammich Mount 3D Printer Model
The file '4runner Ram Sammich Mount 3D Printer Model' is (stl) file type, size is 401.4KB.
The file '4runner Ram Sammich Mount 3D Printer Model' is (stl) file type, size is 401.4KB.
Work in progress so no promises!! Ram ball has a hole for M4 35mm bolt. Probably will need to slightly drill to fit.
Original: first prototype, was a good length, but a little narrow.
W/ Taper: added 3/16" taper to each side and took 1/4" off the bottom to get it to wedge it in. Untested, please pass along feedback of build!
Wide: the original, but 3/16" added to each side. Untested! This may be snug!! Please pass along feedback
W/ Holes: Holes should fit tubes of chapstick
| 4runner_Center_Console_Ram_Mount_with_taper.stl | 90.6KB | |
| 4runner_Center_Console_Ram_Mount_with_taper_and_holes.stl | 116.0KB | |
| 4runner_Center_Console_Ram_Mount_with_Taper_TRD.stl | 474.8KB | |
| Original_4runner_Center_Console_TRD.stl | 334.3KB | |
| Wide_4runner_Center_Console_Ram_Mount.stl | 89.8KB |
