42×42 Stepper Motor Mount On Flat Surface 3D Printer Model
The file '42×42 Stepper Motor Mount On Flat Surface 3D Printer Model' is (stl) file type, size is 65.2KB.
The file '42×42 Stepper Motor Mount On Flat Surface 3D Printer Model' is (stl) file type, size is 65.2KB.
Mounts for stepper motors with 42x42mm front section (fit for NEMA).
This is a custom design I needed for a specific DYI project (intended for mounting on a flat surface), however I publish them here in case they fit anyone else's purpose.
There are 2 versions, one with a short base and another with a longer footprint.
Mounting screw holes are 10-15mm ovals to allow position adjustment on 2 axes, vertical and along the shaft.
M3 screws for tightening the motor, M5 or M6 screws for mounting on surface.
Motors stand on rails allowing better airflow for cooling. If you expect the motor to become hot during operation (higher load), print in temp-resistant materials e.g. nylon, ASA or at least PETG.
| nema_42x42_mount_long_base.stl | 126.6KB | |
| nema_42x42_mount_short_base.stl | 181.9KB |
