I got tired of my skyzones alarming at 50% of li-ions' capacity and powering off (~6.9v)
3s works good, just set the powersource to 2s or dc-in and watch out for the end voltage, it will be something like 9.5v. Mine shows reading +0.1v under load, so check yours with a voltmeter, before you decide when to power it off at.
NOTE: it is a nonseparable pack. You have to solder the cells and use glue to assemble the case!
!!!!!!!!!!!!!!Printing notes!!!!!!!!!!!!!!!!
Suggested materials:
Grommet - any flexible
Other parts - any hard plastic, i prefer ABS - acetone solution fuses everything together nicely
Upscale up_cap , cap, bottom_cap to 101%, otherwise it wont slide on the core part.
You can print all these 3 parts at once.
| bottom_cap.STL | 7.2MB | |
| cap.STL | 2.9MB | |
| core.STL | 149.3KB | |
| grommet_b.STL | 865.4KB | |
| up_cap.STL | 2.3MB |
