3DVK Euro 4 Holes THiNK Remix For Stacking 3D Printer Model
The file '3DVK Euro 4 Holes THiNK Remix For Stacking 3D Printer Model' is (STL) file type, size is 14.1MB.
The file '3DVK Euro 4 Holes THiNK Remix For Stacking 3D Printer Model' is (STL) file type, size is 14.1MB.
Updated version of the Euro 4hole remix to allow for easier part stacking. Designed for use with 0.3mm layer height, and considerably ramped up speeds. Can print 50 pieces in under 24 hours with the suggested settings.
All the usuals apply, can break the parts off with a flat head spanner, or a small steel rule is my preference.
There are a couple of changes to the original file to aid stacking, mainly the filling in of the front part (as per Erik Cederberg's advice), and adding in nubs to the upper surface.
As I use Prusa Slicer, if you try and stack with a blank layer it won't slice. So the nubs are a work around for this, and are set to be the same space as the layer gap (0.3mm). One additional positive is that they also allow for faster bridging speeds, as the filament will touch and secure on the nubs, and reduce stray filament.
Included STL files for single piece, as well as 5, 10, 15, 20 and 25 sets.
These frames use the european 4hole setup as per original file, so use a 2 hole punch on 888 setting (slightly smaller than A6).
| 3DVK_THiNK_Remix.STL | 1.6MB | |
| 3DVK_THiNK_Remix_-_10pc_Stack.STL | 19.1MB | |
| 3DVK_THiNK_Remix_-_15pc_Stack.STL | 28.6MB | |
| 3DVK_THiNK_Remix_-_20pc_Stack.STL | 38.1MB | |
| 3DVK_THiNK_Remix_-_25pc_Stack.STL | 47.6MB | |
| 3DVK_THiNK_Remix_-_5pc_Stack.STL | 9.6MB |
