3D Snowflake Ornament In Three Pieces 3D Printer Model Download Free STL File

Description Files

Summary

This is an OpenSCAD design for a snowflake ornament with three flat parts that slot together at 120 degree angles to form a 3D structure. The STL provided is 9.5 cm (3.75 in) in diameter.

The parts are directional and fit together in precisely one way. You can solve it like a puzzle or follow the spoiler instructions below. When disassembled, the ornament can be stored or mailed in a flat envelope.

Lay part1, part2 and part3 face up (as printed), side-by-side in a row, as shown in the annotated picture. Note that part1 has a small barb on the main tine, whereas part3 doesn't.
Lift part1 straight up off the table with your left hand. Lift part2 straight up with your right hand. Tilt part2 120 degrees away from you (Y axis). Slide part2 to the left into part1, with the part2 slot matching the part1 slot that is closest to you.
Keeping your left hand the same, lift part3 straight up with your right hand. Tilt part3 120 degrees toward you. Slide part3 in to the left so its main tine will lie on top of the two main tines that are already mated.

When part3 is half way in, you may feel some resistance due to the retention barb forcing tines apart. Once pressed all the way in, the barb will catch on part1 and part2 wlll be held captive between part1 and part3. If you print it without the barb (customizer window in OpenSCAD), the pieces will slot together very easily, but they'll also fall apart very easily. A couple drops of superglue will keep it together permanently.

part1.stl

part2.stl

part3.stl

snowflake-slotted.scad

snowflake-slotted.stl

3D Snowflake Ornament In Three Pieces 3D Printer Model

Summary

Tags

You might also like