3D Printed RC Truck V3: Center Diff V2 3D Printer Model
The file '3D Printed RC Truck V3: Center Diff V2 3D Printer Model' is (STL) file type, size is 1.2MB.
The file '3D Printed RC Truck V3: Center Diff V2 3D Printer Model' is (STL) file type, size is 1.2MB.
Updated center differential for the V3 truck project!
Features:
More streamlined, less chance of getting stuck
Improved driveshaft angles, less chance to break the small shaft to gearbox
Higher gear ratio to get the RPM down
You can check out the other videos of this project at:
http://www.youtube.com/c/MrCrankyfaceProjects.
Hardware needed:
3x countersunk m3x10
2x M3x10
2x M3x16
4x 15x10x4 bearings
For more V3 parts, check out my V3 collection:
http://www.thingiverse.com/MrCrankyface/collections/printed-rc-truck-v3
Check me out at:
Youtube: http://www.youtube.com/c/MrCrankyfaceProjects
Instagram: https://www.instagram.com/mr.crankyface/
3d hubs: https://www.3dhubs.com/malm%C3%B6/hubs/mrcrankyface
Patreon: http://patreon.com/Mrcrankyface
| diff_center_v2_-_Axle_center_CaseA_v2.STL | 533.6KB | |
| diff_center_v2_-_Axle_center_CaseB_v2.STL | 540.8KB | |
| diff_center_v2_-_Axle_center_DiffA_v2.STL | 383.1KB | |
| diff_center_v2_-_Axle_center_DiffB_v2.STL | 176.8KB | |
| diff_center_v2_-_Axle_center_Halfaxle_v2_x2.STL | 142.7KB | |
| diff_center_v2_-_Axle_Center_Ujoint_v2_x3.STL | 436.2KB | |
| diff_center_v2_-_Axle_diff_gear_x2.STL | 731.8KB | |
| diff_center_v2_-_Smallgear_v2.STL | 307.8KB |
