This is the gimball i made with T-flex and i printed it on 3D working fine.
No springs in that simulation.
Check the actual printed model here :
https://www.youtube.com/watch?v=zzf8GmdlMfk
Check the CAD video here :
https://www.youtube.com/watch?v=QFAw2bznCdk&t=0s
Screw are plastic screw 2.5mm diameter 8mm long.
You need to find springs or make your own. Springs are made of 0.6mm diameter wire, 8 turns on 4mm bar.
(new upload because of issues on youtube video)
edit : added 3D pdf
Printing:
Ring - Infil to add weight, supports needed for spade inset. Letter embossing doesn't need it.
Spade - Infil to add weight, no supports
Letters - Print flat, already scaled to fit nicely in the embossing
Star - Infil to add weight.
Full print with 4x4x4 walls/top/bottom and 38% infil came to about 48g in weight.
Glue in lettering and spade. Star may need minor sanding but should push fit into the space tightly and not need anything else to secure it.
| joy_axePri2.stl | 82.6KB | |
| joy_Corps.stl | 84.3KB | |
| joy_CotePotar.stl | 41.3KB | |
| joy_CoteSoutien.stl | 64.8KB | |
| joy_manche.stl | 9.5KB | |
| joy_Part1.stl | 115.7KB | |
| joy_Part2.stl | 21.4KB | |
| joy_Part3.stl | 114.7KB | |
| joy_SuppRessort.stl | 19.8KB | |
| joy__ass_joystick_p2.pdf | 3.2MB |
