A 3D Printed Electric Ukulele.
Requires numerous non 3D printed parts.
--
The sound is pleasant, but printed in PLA the body is very compliant, and it took a while after being printed for it to settle down and remain in tune for any period of time.
--
In the two years since I built this, it has suffered from slight warping caused by the tension of the strings. If I was re-designing it, I'd probably replace the threaded rod that runs through the Ukulele with a thicker one. I'd also either glue the bridge on, using a strong glue, or integrate the bridge into the design.
| body.stl | 317.8KB | |
| bridge.stl | 5.0KB | |
| head.stl | 198.6KB | |
| horns.stl | 210.3KB | |
| lid.stl | 64.0KB | |
| neck.stl | 44.5KB | |
| printable_uke.blend | 1.3MB | |
| symmetrical_head.stl | 198.2KB | |
| uke.blend | 1.0MB |
