Many Standing desks suffer from poor cable management due to all the cables having to be twice as long to support the desk moving up and down. Initially, I used some cable management sleeves to bundle the cables together however, this just meant that instead of having loads of cables dangling and getting caught I had only a couple of really thick cables. This presented multiple issues where the cables would get caught and then rip off the equipment potentially damaging them. I finally decided to print a cable management arm that would be fixed to the table and allow the cables to move only in a certain way. The standing desk legs that I used are linked below:
| Base_Clamp.stl | 90.3KB | |
| Cable_Arm_Bolt_v21.f3z | 1.2MB | |
| Cable_Arm_Bolt_v21.step | 563.4KB | |
| Cable_Arm_Bolt_v21.stl | 2.7MB | |
| Cable__3_Link_Arm_Bolt_v5.f3z | 1.2MB | |
| Cable__3_Link_Arm_Bolt_v5.step | 548.6KB | |
| Cable__3_Link_Arm_Bolt_v5.stl | 1.1MB | |
| Clamp_Fastener.stl | 680.0KB | |
| Desk_Clamp.stl | 72.0KB | |
| Link.stl | 99.5KB | |
| Push_Fit_Bolt_v4.stl | 49.5KB | |
| Technical_Drawing.pdf | 189.1KB |
