This print is ready to go and does not need any more fixing to be printed!
3D Print other RWBY models here:
https://www.thingiverse.com/thing:2357481 Ruby Rose
https://www.thingiverse.com/thing:2397963 Weiss Schnee
https://www.thingiverse.com/thing:2447958 Blake Belladonna
https://www.thingiverse.com/thing:2471634 Yang Xiao Long
https://www.thingiverse.com/thing:2504153 Velvet
https://www.thingiverse.com/thing:2753068 Nora
https://www.thingiverse.com/thing:2846440 Zwei (dog)
Join the Anime Figure group and share and print anime figures! As well as Updates on what im doing next https://www.thingiverse.com/groups/animefigures
Support me on Patreon! https://www.patreon.com/AnimuAnimu/posts
This print already has all the support material ready to go, DO NOT add SUPPORT MATERIAL.
the support material that i already added to the file has tapered ends and easily breaks off, however be very careful removing, especially around the head. no cutting or gluing necessary.
DO NOT PRINT WITH A RAFT OR SUPPORT MATERIAL
there are THREE stl files included, PRINT THE 3DPrintReady FILE. I included files of the print without supports and one without the base if you want to add your own supports. note a base is necessary or the model will tip over.
it is a good idea to add some pauses toward the tip of the sickle so that the point has enough time to cool and doesnt end up all melted like mine
i included my Cura print settings if you were curious, however you should switch to like a .05 mm layer height and a slower print speed to make it look better. if i get around to it, ill print it again at slower speed and post more pictures. i printed mine kind of fast.
i did a bunch of smoothing in Meshmixer, so the stl file is quite big even after being 'reduced' so be patient!
i only had black PLA on hand, im sure a white plastic will make the details show up better, especially in pictures. and wont leave white spots where the support material attatched.
| 3DPrintReadyRubyRose.stl | 103.8MB | |
| NoBaseRubyRose.stl | 85.9MB | |
| NoSupportsRubyRose_add_your_own_supports.stl | 85.9MB | |
| test_file_ignore_this_4.stl | 89.7MB | |
| ThickerSupportsForPrintingSmallerSizedFixed.stl | 88.2MB |
