Check out my newest Miku Model here: https://www.thingiverse.com/thing:2889125

edit: i just reuploaded the stl file to print better flat, the hair in the first file was extending too far down, i plane cut it so it prints perfect now. if you have already downloaded the file, re download the new one :)

Join the Anime Figure group and share and print anime figures! https://www.thingiverse.com/groups/animefigures
Support me on Patreon! https://www.patreon.com/AnimuAnimu/posts

This print is ready to go and does not need any more fixing to be printed

IMPORTANT: this MUST be printed with a RAFT or it will collapse!
This print already has all the support material ready to go, DO NOT add SUPPORT MATERIAL.
the support material that i already added to the file has tapered ends and easily breaks off, however be very careful removing, especially around the head. no cutting or gluing necessary.

also i printed this out very rough and fast to see if it would work, i also used a black sharpie to color in any white marks from removing the support material because i roughly broke it off. the marker looks much better and subtle in person.

i included my Cura print settings if you were curious, however you should switch to like a .05 mm layer height and a slower print speed to make it look better. if i get around to it, ill print it again at slower speed and post more pictures.

i did a bunch of smoothing in Meshmixer, so the stl file is quite big even after being 'reduced' so be patient!

i only had black PLA on hand, im sure a white plastic will make the details show up better, especially in pictures.