The file '3d Catan Box 3D Printer Model' is (stl) file type, size is 3.4MB.
This is a box/holder for a 3d printed Settlers of Catan set. This has been sized to fit the 80mm hex tiles board pieces. Tolerances in this model are tight, but the tolerances of the board tiles to fit in the board make for good clearance in the box. Use a piece of wire <2mm for the hinges. 25.5mm holes have been added to the lids for gluing in ceramic magnets. This was designed to fit the tiles set posted by JAWong (link below), but this should fit many of the sets available. Minimal supports required for the lid. A little sanding my be required on the tab for the base pieces before gluing depending on your printer tolerance.
https://www.thingiverse.com/thing:26979
Update 3/21/19: Added bases without inserts upon request
Base1.stl | 1.1MB | |
Base1_nofill.stl | 288.2KB | |
Base2.stl | 1.6MB | |
Base2_nofill.stl | 368.8KB | |
Lid1.stl | 5.3MB | |
Lid2.stl | 6.1MB |