I got tired of my big pry bars falling over when my chain hoist hits its bump stop. So I made this holder that holds them upright. I placed these ( https://www.amazon.com/dp/B09QFWKLTS?psc=1&ref=ppx_pop_dt_b_asin_title ) magnets on the back and set them with epoxy. Id cover them with tape if you're going to put on something painted to keep them from scratching.
One holder won't be enough to fully support them, but two would do it. I just needed them to be upright and out of the way
Printed at .3mm resolution and 40% infill but <20% would work.
| 36in_H_F_Pry_bar_holder_v1.stl | 3.0KB |
