THIS IS AN UNPRINTED UNTESTED PROTOTYPE
I crudely solid modeled this part just based off of various measurements of one side insert, photos, and from some traced sketches. This likely WILL NOT FIT RIGHT AWAY.
However,
I modeled it with slightly more tolerance than less, so that if it does fit it will be snug, and can be sanded, shaped, and modified by hand to fit. It does NOT have the little plastic clips on the sides to hold it in, so if you do get it to fit, you will need to adhere it down with butyl tape or glue it in. I would advise against gluing it since there is no hole for aiming the fog light.
If you print this, PLEASE let me know if it fits, and if not what you had to do to make it fit, or if its just completely wrong.
| 300zx_Fog_Light_Insertsd_side.stl | 51.3KB | |
| 300zx_Fog_Light_Insertsp_side.stl | 51.3KB |
