Source: https://www.thingiverse.com/thing:6382612 and https://www.thingiverse.com/thing:227635
The narrow part of the prongs is 30 mm wide and 10 mm long.
It can be installed without cutting the loop that held the old clip, instead, it is held in place by two M3 screws and heat-set thread inserts (see photos).
Fits perfectly for the belt of a kid's bathrobe by the German company "Jako-o" or British company "London Fog,"
Required materials
- Two M3 heat-set threaded inserts
- Two M3 screws, length <= 16 mm
... or if one needs to avoid metals all together - Zip tie with l length of 80cm+ and width of 3mm
Print Settings
- Rafts: Doesn't Matter
- Supports: Yes
- Resolution: 0.10-0.16
- Outlines: 3 or more
- Outer layers: 3 or more
Post-Printing
- Installation
- Remove supports
- Add heat-set M3 inserts into bar
- Cut away the old, broken clip (don't cut the loop of fabric)
- Put bar into the loop where the old clip was
- Fasten with two M3 screws (length <= 16 mm)
