3 AA Battery Holder 3D Printer Model
The file '3 AA Battery Holder 3D Printer Model' is (stl) file type, size is 17.4KB.
The file '3 AA Battery Holder 3D Printer Model' is (stl) file type, size is 17.4KB.
This is a holder for 3 AA batteries. This component should produce about 4.2 volts if the batteries are alkaline and fully charged. I used this thing as a power supply for my ATMEGA328p-pu (an Arduino). 4.2 volts is a good amount to use to power any 5V component using AAs; if you use 4 AAs you would be giving too much power, but giving slightly under power should work fine.
See how to assemble the batteries in a series below in the Post-Printing area.
FYI: The hole in the middle of this thing is for some wires to go down if you don't have much space for wires around this thing (like I did in the picture attached).
| 3_AA_Battery_Holder.stl | 70.3KB |
