Because DaneC hasn't mass-produced his 2x2 X-Cube yet, I decided to make my own. I only printed the X-Cube variation, but the cross cube mechanism is nearly identical and I have included both sets of files.
To make the 2x2 X-Cube print the following:
To make the 2x2 Cross Cube print the following:
You need 3 M3 screws and 3 springs. You can buy them here:
https://thecubicle.us/moyu-weilong-hardware-p-1666.html
The 17mm screws I used were too long, so I ground them down to 12mm. Make sure to leave some of the screw's thread left, or else it won't work.
Standard 2x2 stickers can be used.
| center_x3.stl | 660.2KB | |
| cross_alignment_x1.stl | 909.1KB | |
| cross_corner_x7.stl | 657.2KB | |
| edge_x9.stl | 317.7KB | |
| extension.stl | 137.6KB | |
| X_alignment_x1.stl | 685.7KB | |
| X_corner1_x4.stl | 460.5KB | |
| X_corner2_x3.stl | 460.5KB |
