2nd Generation Chevrolet Chevy Silverado Phone Holder 2007-2013 3D Printer Model
The file '2nd Generation Chevrolet Chevy Silverado Phone Holder 2007-2013 3D Printer Model' is (stl,3mf,f3d) file type, size is 293.5KB.
The file '2nd Generation Chevrolet Chevy Silverado Phone Holder 2007-2013 3D Printer Model' is (stl,3mf,f3d) file type, size is 293.5KB.
V3
Moved the phone farther out and angled/tilted it up/back at 75 degrees (or leans back 15 degrees). I removed the bracing and printed in PETG and it's been working fine.
Added Fusion 360 files (f3d, 3mf, stl).
V1
Designed to fit the passenger-side cubby but at a 45* angle to face the driver.
It uses the two holes for the rubber mat that fits in there to hold it in place, wedging against the top in the back.
I measured for an iPhone 13 with a case: 79mm wide, 13.5mm deep, and 75mm tall supports. Charging port is 13.5mm X 6.5mm, offset slightly towards the front.
This is an original design I made, and the bracing is way overkill, but I printed in PLA and am hoping it'll keep it from warping too bad in the South Texas heat.
| Chevy_Silverado_Phone_Holder.stl | 29.6KB | |
| Chevy_Silverado_Phone_Holder_Angled_v3.3mf | 94.1KB | |
| Chevy_Silverado_Phone_Holder_Angled_v3.f3d | 191.0KB | |
| Chevy_Silverado_Phone_Holder_Angled_v3.stl | 19.4KB |
