This is an ADAPTER. it requires the lower portion of a t100 cupholder ($15 complete assembly on Amazon). beats the $90 hilux drop in replacement. Image shows which part is needed.
Simply order a t100 cupholder, print this part, remove the lower bracket from the t100 cupholder and install it onto the printed part. then it should slide right into the 2nd gen dash slot. it works great for me 2 years later.
Definitely room for improvement, especially aesthetically, adding some curves and getting the dimension perfect. I will not be doing all of that modelling but I welcome anyone else to try.
Print ABS/ASA/PC %100 infill.
SUPPORTS REQUIRED, paint on supports on the small clips over the rear edge as shown in picture. should be as easy to remove as possible.
| 1991_4runner_Cupholder_V1.2.par | 612.0KB | |
| 1991_4runner_Cupholder_V1.2.stl | 45.2KB |
