Please note that the scaling in the STL is way off, you have to manually set it. Also I'd recommend printing it much thinner.
The print in the third picture is old. I have dropped it so many times that it has broken at the edges. It doesn't come out that way.
Can't recall if I printed it at 0.1 or 0.2 layer height. So I'm setting 0.1 on the instructions.
5th picture has the scaling settings I used for the newest print.
This model is based on a very similar picture. Which I edited to a model. I would credit the original artist but the picture is long gone.
| maapallo.stl |
