2AA Battery Box With Switch 3D Printer Model
The file '2AA Battery Box With Switch 3D Printer Model' is (stl) file type, size is 316.9KB.
The file '2AA Battery Box With Switch 3D Printer Model' is (stl) file type, size is 316.9KB.
A battery box for 2 AA batteries fitted with a slide switch and using common battery contact plates 25 x 12.7 mm and ~15 mm terminal spacing
The photographs show my 1.0 version, which used coutnsunk screws to hold the switch in from above; this required modification of the switch to remove the threads and then countersinking of the holes
Required for assembly
Base & Lid
2 battery contact plates, 25 x 12.5 mm, eg Keystone 5212 One fo the plates should cut in 2 for use at the switch end; alternatively 2 separate plates can be used. I just used some salvaged plates that were in my spares box.
Miniature Slide switch, 19 mm hole spacing with M2 threads, eg Knitter-Switch MFS131D
4 M2 x 6* countersunk screws to secure the lid (*6 mm min, can be 10 mm long), eg , eg M2 CSK Pozi Stainless Steel
2 M6 x 10 countersunk screws for the slide switch (length important), eg M2 CSK Pozi Stainless Steel
Cable to suit intended use (I use a piece of 5m Servo Wire 26awg Futaba JR 3-Pin (with the white cable stripped off)
| 2AA_SW_Case_v1_2_all.stl | 1.5MB | |
| 2AA_SW_Case_v1_2_base.stl | 604.3KB | |
| 2AA_SW_Case_v1_2_lid.stl | 957.1KB |
