28mm Playing Card Warriors 3D Printer Model
The file '28mm Playing Card Warriors 3D Printer Model' is (stl) file type, size is 894.0KB.
The file '28mm Playing Card Warriors 3D Printer Model' is (stl) file type, size is 894.0KB.
If you are a fan of Lewis Carroll, Gygax's Dungeonland, Disney, or just the whimsical, these Playing Card Warriors might be perfect for you games.
These print flat. you can easily pose them by dunking them in near boiling water for a few seconds. Once the PLA become pliable, you can use your fingers to shape them. CAUTION: BE CAREFUL WHEN WORKING WITH HOT WATER [Youngsters should ask a parent or guardian for assistance]. Glue the feet on and then glue to the base.
I designed this from the ground up by looking at pictures and then I filled in the blanks with my own ideas. The original IP is controlled by Disney and they reserve the right to take it down or use the files however they see fit. This model and file set cannot be sold anywhere.
| Playing_Card_2.stl | 174.9KB | |
| Playing_Card_3.stl | 200.1KB | |
| Playing_Card_4.stl | 170.6KB | |
| Playing_Card_5.stl | 195.6KB | |
| Playing_Card_6.stl | 214.2KB | |
| Playing_Card_7.stl | 186.5KB | |
| Playing_Card_Base.stl | 163.4KB | |
| Playing_Card_Foot_L.stl | 525.7KB | |
| Playing_Card_Foot_R.stl | 525.7KB | |
| Playing_Card_Sword_Half.stl | 50.8KB |
