250 Quade Racer 3D Printer Model
The file '250 Quade Racer 3D Printer Model' is (stl) file type, size is 975.2KB.
The file '250 Quade Racer 3D Printer Model' is (stl) file type, size is 975.2KB.
Tested 8/25: Flies like a Scalding Ape!! Have not mounted the Fatshark or Gopro Session to it yet, but I am confident that it will still perform and have plenty of power. Parts used below:
Turnigy 3cell 2200mah
Emax 15amp ESC
ARRIS 1806 2300kv Brushless motors
KK2 Flight Controller (also set up to run DJI Naza light)
Spectrum 6ch Receiver
5045 Genfan props
COMPLETED 8/18/16 : Finished Printing complete. Adding Hardware and Electronics. . Added landing gear. Landing gear optional or you can use four points when installing the upper slab and utilize 3" bolts as shown.
Quade Arms: .2 Resolution ,75% Lateral Infill ,w/Supports, No Raft
Lower Slab: .2 Resolution, 40% Infill, No Supports, No Raft
Upper Slab: .2 Resolution, 40% Infill, No Supports, No Raft
Landing Gear: .2 Resolution 100% Infill w/Raft and Supports
Both Canopies: .2 Resolution, 10% Infill, W/Raft and Supports
UPDATE 8/15 Printed well had to make some changes to the motor mounts. Updated original design.
UPDATED: Just finished design and have not printed. Will update once kinks are worked out if any. ADDED: .thing and .x3g Files
| QUADCANOPY.stl | 175.2KB | |
| V2_COMPLETED_QUADBOLTED.stl | 3.4MB | |
| V2_Landing_Gear.stl | 121.8KB | |
| V2_OPTION2_COMPLETED_QUADBOLTED.stl | 3.4MB | |
| V2_QUADARMLEFT.stl | 783.3KB | |
| V2_QUADARMRIGHT.stl | 807.5KB | |
| V2_QUADCANOPY.stl | 191.7KB | |
| V2_QUADSLAB.stl | 1.3MB | |
| V2_QUADSLABUPPER.stl | 505.0KB |
