Drawer that mounts under a beam of 2020 sized aluminum extrusion. A couple of NinjaFlex filament rails along the sides of the draw can be added, this will prevent the draw from sliding open when moving the printer. This drawer is small, just large enough for some hex wrenches, but the design is public in Onshape so you can adjust it to any size you want, just click the Onshape link below.
Parts:
Printer:
Design:
Filaments: (full list can be found on thrinter.com)
*affiliate link
| 2020_Drawer_-_Drawer.stl | 1.2MB | |
| 2020_Drawer_-_Left_Slide.stl | 149.7KB | |
| 2020_Drawer_-_Right_Slide.stl | 149.7KB |
